Installing A Cd-Rom/Dvd Drive - ECS P6IEMT Manual

Installing a CD-ROM/DVD Drive

1. Install the CD-ROM/DVD drive into the drive cage in
your Micro ATX system case.
2. Plug the IDE cable into IDE1 (A). If you have already
installed an HDD, use the other connector on the IDE
cable.
CD-ROM audio
connector
D
CD2
CD1
Note: Ribbon cable connectors are usually keyed so that
they can only be installed correctly on the device
connector. If the connector is not keyed, make sure
that you match the pin-1 side of the cable connector
with the pin-1 side of the device connector. Each
connector has the pin-1 side clearly marked. The
pin-1 side of each ribbon cable is always marked
with a colored stripe on the cable.
CD-ROM
B
A
Pin 1
22
C