Important Instructions On Use; Intended Use; Introduction; Use And Application Cases - Bosch Rexroth IndraControl S67 Manual

DOK-CONTRL-S67DIO4M12H-AP02-EN-P
Rexroth IndraControl S67 Digital Module High Speed 4 Inputs/Outputs – 0.2 A (84×M12)
2

Important Instructions on Use

2.1

Intended Use

2.1.1

Introduction

2.1.2

Use and Application Cases

The Rexroth products represent state-of-the-art developments and manufac‐
turing. The products are tested prior to delivery to ensure operating safety
and reliability.
The products may only be used for the intended purpose. If the products are
not used as intended, situations causing personal injury as well as material
damage can occur.
Rexroth shall not be liable for damages resulting from unintended
use. In such cases, the guarantee and the right to payment of
damages resulting from unintended use are forfeited. The user
alone carries all responsibility of the risks.
Before using Bosch Rexroth products, the following requirements must be
met to ensure intended use of the products:
● Personnel who in any way, shape, form or use one of our products must
first read and understand the relevant safety instructions and be familiar
with the intended use of the products
● If the product takes the form of hardware, then the products remain in
the original state, in other words, no structural changes to the products
are permitted. The decompilation of software products or the alteration
of source codes is not permitted
● Do not install or operate damaged or faulty products
● Ensure that the products have been installed in the manner described in
the relevant documentation
Depending on how it is parameterized, the S67-DIO4-HS-M12 module is
used to emit digital signals that are specified by a higher-level controller (e.g.,
field bus coupler) and/or record digital field signals, such as sensors.
The S67-DIO4-HS-M12 module must not be used to control safety-related
functions, e.g. emergency-off equipment must not be operated with the S67-
DIO4-HS-M12 module.
The S67-DIO4-HS-M12 module shall only be used in combination with a field
bus coupler and I/O module of the IndraControl S67 series.
The S67-DIO4-HS-M12 module was developed for applications requiring
IP67 (NEMA type 6, 6P) degree of protection.
The S67-DIO4-HS-M12 module is supported by IndraControl S67 field bus
couplers that correspond to the technical index listed in the table. The techni‐
cal data is printed on the type plate. See also
18.
Bosch Rexroth AG
Important Instructions on Use
fig. 4-5 "Type plate" on page
9/79