Troubleshooting - Panasonic SC-MAX370 Operating Instructions Manual

To connect a VCR, DVD player etc.
You can connect a VCR, DVD player etc. and listen to
the audio through this system.
Audio cable
(not supplied)
DVD player (not supplied)
Rear panel of this main unit
1
Connect the external equipment.
2
Press [RADIO/EXT-IN] to select "AUX".
3
Play the external equipment.
Note:
• If you want to connect equipment other than those
described, refer to the audio dealer.
• Sound distortion can occur when you use an adapter.
18
18

Troubleshooting

Before requesting service, make the following checks.
If you are in doubt about some of the check points, or if
the solutions indicated do not solve the problem, consult
your dealer for instructions.
Common problems
The unit does not work.
• One of the unit's safety devices may have been
activated.
Reset the unit as follows:
1 Press [Í/I] on the main unit to switch the unit to
standby.
• If the unit does not switch to standby, press [Í/I]
on the main unit for a few seconds. The unit is
forcibly switched to standby. Alternatively,
disconnect the AC mains lead, wait one minute,
then reconnect it.
2 Press [Í/I] on the main unit to switch it on. If the
unit still cannot be operated, consult the dealer.
The display panel lights up and changes
continuously in standby mode.
• Press and hold [∫] on the main unit to select "DEMO
OFF".
No operations can be done with the remote control.
• Examine that the battery is installed correctly.
Sound is distorted or no sound.
• Adjust the volume of the system.
• Switch off the system, determine and correct the
cause, then switch the system on again. It can be
caused by straining of the speakers through excessive
volume or power, and when using the system in a hot
environment.
A humming sound can be heard during playback.
• An AC mains lead or fluorescent light is near the
cables. Keep other appliances and cords away from
the cables of this system.
The sound level reduces.
• The protection circuit has been activated due to the
continuous use at high volume output. This is to
protect the system and maintain the sound quality.
Disc
Display not shown correctly.
Playback does not start.
• You have not put in the disc correctly. Put it in correctly.
• Disc is dirty. Clean the disc.
• Replace the disc if it is scratched, warped, or
non-standard.
• There is condensation. Let the system dry for 1 to
2 hours.
The total number of tracks displayed is incorrect.
The disc cannot be read.
Distorted sound is heard.
• You put in a disc that the system cannot play. Change
to a playable disc.
• You put in a disc that has not been finalised.
USB
The USB device or the contents in it cannot be read.
• The format of the USB device or the contents in it
is/are not compatible with the system.
• USB devices with storage capacity of more than 32 GB
cannot work in some conditions.
Slow operation of the USB device.
• Large content size or large memory USB device takes
longer time to read.