Page 1
For optimum performance and safety, please read these instructions carefully. Please keep this manual for future reference. If you have any questions, contact: 1-800-211-PANA (7262) Register online at www.panasonic.com/register (U.S. customers only) La referencia rápida en español se puede encontrar en la página 16. RQT9840-P...
IMPORTANT SAFETY Do the procedures with the remote control. You can also use the buttons on the main unit if they are the INSTRUCTIONS same. Your system and the illustrations can look differently. These operating instructions are applicable to the following system.
Safety precautions Battery • Do not break open or short-circuit the battery. • Do not charge the alkaline or manganese battery. • Do not use the battery if the cover has peeled off. WARNING! • Do not heat or expose to flame. •...
(2) this device must accept any interference received, including interference that may cause undesired operation. Responsible Party: Panasonic Corporation of North America One Panasonic Way, Secaucus, NJ 07094 Support Contact: Panasonic Consumer Marketing Company of North America Telephone No.: 1-800-211-PANA (7262)
Attaching the speaker feet Placement of speakers • Keep your speakers more than 10 cm (4") from the main unit for ventilation. • Put the speakers on a flat safe surface. For stability and to prevent damage to the floor, attach the Tweeter •...
Overview of controls SLEEP PLAY EXT-IN RADIO ILLUMINATION PRESET EQ SOUND D.BASS PRESET EQ MANUAL EQ D.BASS RADIO TUNE MODE DISPLAY DIMMER SUPER WOOFER EXT-IN ALBUM/ OPEN/ TRACK CLOSE MIC VOL MUSIC PORT MIN MAX DISPLAY AUTO OFF DIMMER...
Preparing the remote control Standby/on switch [`], [1] Browse tracks or albums Press to switch the unit from on to standby mode or vice versa. In standby mode, the unit is still Turn [CONTROL] to browse the track. consuming a small amount of power. Press [4/9] to start playback from the selection.
Making the connections Connect the FM indoor antenna. Put the antenna where reception is best. Connect the AC power supply cord only after all the other connections have been made. Tape Connect the AM loop antenna. Stand the antenna up on its base until it clicks. Connect the speakers.
Disc Play menu 1. Press [R, T] to select the desired album. 2. Press [6] and then press the numeric Press [PLAY MENU] to select “PLAYMODE” or Playing disc buttons to select the desired track. “REPEAT”. 3. Press [OK]. Do these steps again to program other tracks. Press [x OPEN/CLOSE] on the main unit to open Press [Y, U] and then press [OK] to select the the disc tray.
Radio Memory presetting You can connect and play music tracks from your USB 30 FM and 15 AM stations can be preset. device. Manual tuning Do not use a USB extension cable. The system cannot Automatic presetting recognize USB device connected through a cable. Press [RADIO, EXT-IN] to select “FM”...
Clock and timers FM allocation setting Play timer By main unit only You can set the timer to come on at a certain time to wake Setting the clock you up. This system can also receive FM broadcasts allocated in 0.1 MHz steps.
Sound and illumination DJ effects Illumination effects effects By main unit only By main unit only You can use the DJ effect function to adjust the sound You can change the illumination pattern or color on this Sound effects quality. system.
External equipment Troubleshooting Using the auxiliary input Before connection Before requesting service, make the following checks. If You can connect a VCR, DVD player etc. and listen to the • Disconnect the AC power supply cord. you are in doubt about some of the check points, or if the audio through this system.
Page 14
Remote control code skip that track and play the next one. “REMOTE 1” When other Panasonic equipment responds to the Depending on the USB device, power may be supplied “REMOTE 2” remote control of this system, change the remote control to the USB device connected to USB A port when “USB...
Specifications Disc section General Disc played [8 cm (3″) or 12 cm (5″)] Power supply AC 120 V, 60 Hz Amplifier section CD, CD-R/RW (CD-DA, MP3 ) Power consumption 195 W RMS output power stereo mode Pick up Dimensions (W x H x D) High 330 W per channel (3 Ω), Wavelength...
Disco Spanish quick reference / Menú de reproducción Referencia rápida en español Pulse [PLAY MENU] para seleccionar Cómo reproducir disco “PLAYMODE” o “REPEAT”. Pulse [x OPEN/CLOSE] en la unidad principal Pulse [Y, U] y después pulse [OK] para para abrir la bandeja del disco. Cómo realizar las seleccionar el modo deseado.
Page 17
Radio Reloj y temporizadores Usted puede conectar y reproducir pistas musicales Sintonización manual desde su dispositivo USB. Configuración de la hora No use un cable de extensión USB. El sistema no puede reconocer el dispositivo USB conectado a través de un Este es un reloj con un sistema de 12 horas.
Page 18
Efectos de sonido y de la Equipo externo Para cancelar el efecto DJ iluminación Pulse [DJ]. [1] a [6] se ilumina en rojo. Antes de realizar la conexión • Desconecte el cable de alimentación de CA. • Apague todos los equipos y lea las instrucciones Efectos de sonido Efectos de la iluminación operativas adecuadas.
Servicer, or damage that is attributable to acts of God. Purchase Parts, Accessories and Instruction Books online for was not sold “as is”. THERE ARE NO EXPRESS WARRANTIES EXCEPT AS all Panasonic Products by visiting our Web Site at: Mail-In Service LISTED UNDER “LIMITED WARRANTY COVERAGE”. http://www.pstc.panasonic.com For assistance in the U.S.A.