Connecting A Tape Deck; Connecting A Turntable; Connecting A Cd Recorder Or Md Recorder - Denon AVR-2106 Operating Instructions Manual

ENGLISH
Connecting Other Sources

Connecting a tape deck

• If humming noise is generated, move the tape deck further away from the source of such noise.

Connecting a turntable

If humming or other noise is generated when the ground wire is connected, disconnect the ground
wire.
NOTE:
• The phono input can accept signals from moving magnet (MM) and high output moving coil
(MC) phono cartridges. If your turntable is equipped with a low output MC cartridge, you will
need to use a separate MC head amplifier or step-up MC transformer.
If you wish to perform analog dubbing from a digital source, such as a CD or MD recorder to an
analog recorder such as a tape deck, you will need to connect the analog inputs and outputs as
Tape deck
shown below, in addition to the digital audio connections.
AUDIO OUT
A
L
L L
R R
R
AUDIO IN
A
L
L L
R R
R
Turntable
(MM cartridge)
A
AUDIO OUT
L
R
GND
15
ENGLISH

Connecting a CD recorder or MD recorder

NOTE:
• Do not connect the output of the component connected to the OPTICAL 3 OUT terminal on
the AVR-2106's rear panel to any terminal other than the OPTICAL 3 IN terminal (
Connecting Other Sources
CD recorder /
MD recorder
AUDIO OUT
A
L
L L
R R
R
D
OPTICAL
OUT
D
OPTICAL
IN
AUDIO IN
A
L
L L
R R
R
page 42).