Starting Auto Setup - Denon AVR-2106 Operating Instructions Manual

ENGLISH
Easy Setup and Operation

Starting Auto Setup

1
SETUP
Press the button.
• The "System Setup" menu appears.
2
CURSOR D D H H
Press the or
Setup/Room EQ", then press the
• The "Auto Setup/Room EQ" menu appears.
3
CURSOR D D H H
Press the or
ENTER
Setup", then press the
• The "Auto Setup" screen appears.
4 CURSOR D D
Press the or
"Power Amp Assign", then press the
G G
or button to select "S. Back", "ZONE2" or
"Bi-Amp".
When "S. Back" is selected, the test tone during Auto
Setup will be output from the surround back speaker.
When "ZONE2" is selected, change the setting to
"ZONE2". The test tone during Auto Setup is set so that it
will not be output to ZONE2 (Another room).
When "Bi-Amp" is selected, change the setting to "Bi-
Amp". The test tone during Auto Setup is set so that it will
be output from the Bi-Amp speaker.
5
Press the
"Start", then press the
• Start the measurements.
button to select "Auto
ENTER
button.
Measurement of each channel is performed as follows:
FL
button to select "Auto 1: Only the front speakers (A) are measured, front speakers
(B) are not available. Even if the front speakers (B) are
button.
set, the setting automatically switches to the front
speakers (A) once measurements are completed.
2: The subwoofer speaker is measured twice.
3: When "ZONE2" and "Bi-Amp" are selected, these are
not displayed.
After each channel is measured, "Calculating" appears.
The display switches to the Auto Setup check screen
automatically.
H H
button to select
CURSOR F F
CURSOR D D H H
or button to select
CURSOR F F
button.
1 2
FR C SW SL SR SBL
9
ENGLISH
• Measurement is cancelled if the MASTER VOLUME control knob
is operated while the Auto Setup is performed.
• If the output volume and crossover frequency of your
subwoofer speaker can be changed, then set the volume to
halfway and the crossover filter to maximum or switch off
the low-pass filter.
2 About automatic retry
To confirm the results of the measurements, remeasurement is
automatically performed.
Remeasurement is performed up to 2 times. During this time,
"Retry1" or "Retry2" is displayed on the screen.
NOTE:
3
SBR
• When measurements have been made using the
measurement microphone, speakers with built-in filters,
such as a subwoofer, might be set to a value that differs
from the physical distance because of the internal electrical
delay.
Easy Setup and Operation