Table of Contents
Advertisement
Verifying transceiver operation
Verifying transceiver operation
To verify operation of a transceiver, view the LEDs on the transceiver. To find the LED locations on the interface modules, refer to the
section
LED ports behavior
on page 79. After you have connected and configured the ports for Ethernet connectivity and connected
the cable to another active port, the LED becomes solid green. When traffic is detected on the port, the light becomes blinking green.
You can also enter the show interface status and show ip interface brief commands to verify proper transceiver operation.
ExtremeSwitching SLX 9030 Hardware Installation Guide
9035691-02 Rev AD
75
Advertisement
Table of Contents
