Table of Contents
Advertisement
3.
Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 11 Attaching the rear brackets to the device
1.
Screws, 8-32 x 5/16-in., panhead Phillips
Mid-mounting
Observe the following notes when using this procedure:
•
The device must be turned off and disconnected from the fabric during this procedure.
•
The illustrations in this document show a 1U device, but the instructions are the same for a 2U device.
•
The illustrations in the rack installation procedures are for reference only and may not show the actual device.
Complete the following tasks to install the device in a rack:
1.
Attaching the front brackets to the device
2.
Attaching the front brackets to the rack
3.
Attaching the rear brackets to the rack
4.
Attaching the rear brackets to the device
Attaching the front brackets to the device
Complete the following steps to attach the front brackets to the device.
1.
Position the right front bracket with the flat side against the right side of the device, as shown in
ExtremeSwitching SLX 9030 Hardware Installation Guide
9035691-02 Rev AD
on page 37
on page 38
on page 39
on page 40
Installing the Universal Two-Post Rack Kit (XEN-R000294)
Figure
12.
37
Advertisement
Table of Contents
