Table of Contents
Advertisement
Safety precautions
CAUTION
Never leave tools inside the chassis.
CAUTION
If you do not install a module or a power supply in a slot, you must keep the slot filler panel in place. If you run the chassis
with an uncovered slot, the system will overheat.
CAUTION
Use the screws specified in the procedure. Using longer screws can damage the
device.
CAUTION
Do not install the device in an environment where the operating ambient temperature might exceed 50°C (122°F).
DANGER
Batteries used for RTC/NVRAM backup are not located in operator-access areas. There is a risk of explosion if a battery
is replace by an incorrect type. Dispose of used components with batteries according to local ordinance and regulations.
ESD precautions
DANGER
For safety reasons, the ESD wrist strap should contain a series 1 megaohm resistor.
CAUTION
Static electricity can damage the chassis and other electronic devices. To avoid damage, keep static-sensitive devices in
their static-protective packages until you are ready to install them.
CAUTION
Before plugging a cable into any port, be sure to discharge the voltage stored on the cable by touching the electrical
contacts to ground surface.
Power precautions
DANGER
If the installation requires a different power cord than the one supplied with the device, make sure you use a power cord
displaying the mark of the safety agency that defines the regulations for power cords in your country. The mark is your
assurance that the power cord can be used safely with the device.
DANGER
Disconnect the power cord from all power sources to completely remove power from the device.
DANGER
This device might have more than one power cord. To reduce the risk of electric shock, disconnect all power cords before
servicing.
DANGER
To avoid high voltage shock, do not open the device while the power is on.
20
ExtremeSwitching SLX 9030 Hardware Installation Guide
9035691-02 Rev AD
Advertisement
Table of Contents
