Extreme Networks ExtremeSwitching SLX 9030 Series Hardware Installation Manual page 47

4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 19 Positioning the device in the rack
1. Screws, 10-32 x 5/8-in., panhead Phillips
Attaching the rear brackets to the extensions
Complete the following steps to attach the rear brackets to the extensions. There are short and long rear brackets that you can use for this
step. Choose the correct bracket for the depth of your rack.
1. Select the proper length rear bracket for your rack depth.
2. Slide the right rear bracket onto the right bracket extension, as shown in the following figure.
3. Attach the brackets using four 6-32 x 1/4-in. panhead screws.
If possible, leave at least one empty vertical pair of holes between the screws for better support.
4. Repeat step 2 and 3 to attach the left rear bracket to the left bracket extension.
ExtremeSwitching SLX 9030 Hardware Installation Guide
9035691-02 Rev AD
Installing the Universal Four-Post Rack Kit (XEN-R000296)
2. Retainer nuts, 10-32
47