Extreme Networks ExtremeSwitching SLX 9030 Series Hardware Installation Manual page 48

Installing the Universal Four-Post Rack Kit (XEN-R000296)
5. Adjust the brackets to the rack depth and tighten all the 6-32 x 1/4-in. screws to a torque of 9 in-lb (10 cm-kg).
FIGURE 20 Attaching the rear brackets to the extensions
1. Rear brackets
Attaching the rear brackets to the rack posts
Complete the following steps to attach the rear brackets to the rack posts.
1. Attach the right rear bracket to the right rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts, as
shown in Figure 21. Use the upper and lower holes in the bracket.
2. Attach the left rear bracket to the left rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
48
2. Screws, 6-32 x 1/4-in., panhead Phillips
ExtremeSwitching SLX 9030 Hardware Installation Guide
9035691-02 Rev AD