BRP E250DHLSCS Service Manual page 57

If a CANbus water pressure gauge is used, install
Water Pressure Transducer Kit, P/N 5006214, in
the cylinder block.
1. Water pressure transducer
install the transducer lead in the engine wiring
harness connector.
2
3
1. Water pressure transducer lead
2. Engine harness connector
3. Cap
If a CANbus oil level gauge is used, an optional
CANbus oil level sender must be installed in the
oil tank. Connect the oil level sensor harness to
the boat CANbus network.
INSTALLATION AND PREDELIVERY
Use Evinrude Diagnostics software to activate
CANbus control functions in the EMM. From the
Settings screen, select Engine Options.
1
005036
Engine Options Screen
1
004120
OUTBOARD RIGGING
006542
55
2