BRP E250DHLSCS Service Manual page 292

GEARCASE – STANDARD ROTATION
SHIFTER, BEARING AND SEAL SERVICING
Inspect the bearing housing anode. Replace
anode if it is reduced to two-thirds of original size.
Tighten screws to a torque of 108 to 132 in. lbs.
(12 to 15 N·m).
1. Anode
Discard the bearing housing O-rings. Clean the
housing and bearings in solvent and dry thor-
oughly. If bearings were not replaced, rotate the
needles to check for freedom of movement.
Inspect O-ring grooves. Sand off any sharp edges
that might cut O-ring. Remove any nicks or burrs
on front of bearing housing.
1
1. O-ring groove
290
Bearing Installation
Oil, then install new bearings in bearing housing.
Place the lettered end of the bearing case on the
bearing installer, then press the bearing into the
1
housing until the tool seats. When installed, the
lettered end of the bearing should be visible.
S R
TANDARD
Bearing Installation Tool:
P/N 354139 – front and rear bearings
•
1
006897
Front Bearing
1. Bearing installation tool
006898
Rear Bearing
1. Bearing installation tool
H
OTATION OUSING
006909
1
006910