BRP E250DHLSCS Service Manual page 160

ELECTRICAL AND IGNITION
CONNECTOR SERVICING
†
S S
UPER EAL
The J1-A and J1-B connectors of the EMM are
AMP Super Seal connectors.
Disconnect
Depress BOTH latches and pull connector from
plug.
Connect
Push connector into plug until latches engage.
1
1
1. Latch
Terminal Removal
Open lock mechanism and remove terminal from
connector housing.
2
1
1. Latch
2. Lock mechanism
Terminal Installation
Push terminal through seal until it is seated in con-
nector housing. Close lock mechanism.
1
1. Terminal
158
P T
OWER IMER
The J2 connector of the EMM is a AMP Power
Timer Series connector.
Disconnect
Use a screw driver to open latch. Pull connector
from plug.
Connect
Push connector until seated in plug. Close latch
completely.
1
2
002118
1. J2 connector
2. Latch (closed)
Terminal Removal
Use Terminal Release Tool, P/N 351413, to
release BOTH locking mechanisms of connector.
2
Pull terminal from housing.
1
002453
1. Locking mechanism(s)
1. Terminal release tool
002454
†
S
ERIES
002120
1
1
002455
002313