Dot1X Timeout Server-Timeout - D-Link DES-3010FA Cli Manual

dot1x timeout server-timeout

The dot1x timeout server-timeout Interface Configuration mode command sets the time that the device waits for
a response from the authentication server. To return to the default configuration, use the no form of this command.
Syntax
dot1x timeout server-timeout seconds
no dot1x timeout server-timeout
Parameters
•
seconds — Time in seconds that the device waits for a response from the authentication server.
(Range: 1-65535 seconds)
Default Configuration
The timeout period is 30 seconds.
Command Mode
Interface configuration (Ethernet) mode
User Guidelines
The actual timeout can be determined by comparing the dot1x timeout server-timeout value and the result of
multiplying the radius-server retransmit value with the radius-server timeout value and selecting the lower of
the two values.
Examples
The following example sets the time for the retransmission of packets to the authentication server to 3600 sec-
onds.
Console(config)# interface ethernet 6
Console(config-if)# dot1x timeout server-timeout 3600
Page 340
802.1x Commands