Show (Mst) - D-Link DES-3010FA Cli Manual

show (mst)

The show MST Configuration mode command displays the current or pending MST region configuration.
Syntax
show {current | pending}
Parameters
•
current—Indicates the current region configuration.
•
pending—Indicates the pending region configuration.
Default Configuration
This command has no default configuration.
Command Mode
MST Configuration mode
User Guidelines
The pending MST region configuration takes effect only after exiting the MST configuration mode.
Example
The following example displays a pending MST region configuration.
Console(config-mst)# show pending
Pending MST configuration
Name: Region1
Revision: 1
Instance Vlans Mapped
-------- ------------
0 1-9,21-4094
1 10-20
State
-------
Enabled
Enabled
Page 262
Spanning-Tree Commands