Logging Buffered Size - D-Link DES-3010FA Cli Manual

D-Link DES-3010FA/GA/PA CLI Reference Guide

logging buffered size

The logging buffered size Global Configuration mode command changes the number of syslog messages stored
in the internal buffer. To return to the default configuration, use the no form of this command.
Syntax
logging buffered size number
no logging buffered size
Parameters
•
number — Specifies the maximum number of messages stored in the history table. (Range: 20 - 400)
Default Configuration
The default number of messages is 200.
Command Mode
Global Configuration mode
User Guidelines
This command takes effect only after Reset.
Example
The following example changes the number of syslog messages stored in the internal buffer to 300.
Console(config)# logging buffered size 300
Page 271