Dot1X Timeout Tx-Period - D-Link DES-3010FA Cli Manual

D-Link DES-3010FA/GA/PA CLI Reference Guide

dot1x timeout tx-period

The dot1x timeout tx-period Interface Configuration mode command sets the number of seconds that the device
waits for a response to an Extensible Authentication Protocol (EAP)-request/identity frame from the client before
resending the request. To return to the default configuration, use the no form of this command.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
Parameters
•
seconds — Specifies the time in seconds that the device waits for a response to an EAP-request/identity
frame from the client before resending the request. (Range: 1-65535 seconds)
Default Configuration
Timeout period is 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The default value of this command should be changed only to adjust for unusual circumstances, such as unreli-
able links or specific behavioral problems with certain clients and authentication servers.
Examples
The following command sets the number of seconds that the device waits for a response to an EAP-request/iden-
tity frame, to 3600 seconds.
Console(config)# interface ethernet 6
Console(config-if)# dot1x timeout tx-period 3600
Page 337