Copier Problems - Ricoh SP 203 SF Operating Instructions Manual

Copier Problems

Problem
Photocopied paper is blank.
Copied pages are too dark or too
light.
Copied pages do not look the same
as the originals.
Black spots appear when
photocopying a photographic print.
A moire pattern is produced.
Photocopied paper is dirty.
When copying from the exposure
glass, the print area of the copy is
out of alignment with the original.
The paper size setting does not
match the paper loaded.
The original was placed with the front and back reversed.
See page 46 "Placing Originals".
Adjust the image density.
Select the correct scan mode according to the type of original.
The original may have stuck to the exposure glass due to high
humidity.
Place the original on the exposure glass, and then place two
or three sheets of white paper on top of it. Leave the exposure
glass cover open when copying.
The original probably has heavily lined or dotted areas.
Switching the setting for image quality between [Photo] and
[Text/Photo] may eliminate the moire pattern.
• Image density is too high.
Adjust the image density.
• Toner on the printed surface is not dry.
Do not touch printed surfaces immediately after copying.
Remove freshly printed sheets one by one, taking care
not to touch printed areas.
• The scanning part is dirty.
• Before placing originals on the exposure glass, make
sure that toner or correction fluid is dry.
Place the original copy side down, making sure that it is
aligned to the rear left corner and pressed flat against the
exposure glass.
Check whether the paper size specified on the machine
matches that of the loaded paper.
Copier Problems
Solution
175