Ricoh SP 203 SF Operating Instructions Manual page 138

7. Configuring the Machine Using the Control Panel
When DHCP is used, you cannot specify the IPv4 address, subnet mask, or default
gateway address manually.
Default: [On]
• On
• Off
• IP Address
Specifies the machine's IPv4 address when DHCP is not used.
Use this menu to check the current IP address when DHCP is used.
Default: 192.0.0.192
• Subnet Mask
Specifies the machine's subnet mask when DHCP is not used.
Use this menu to check the current subnet mask when DHCP is used.
Default: 255.255.255.0
• Gateway Address
Specifies the machine's default gateway address when DHCP is not used.
Use this menu to check the current default gateway address when DHCP is used.
Default: 192.0.0.192
Machine IPv6 Address
You can configure the wireless LAN IP address.
• Use IPv6
Select whether to enable or disable IPv6.
Default: [On]
• On
• Off
• Link-local Address
Displays the IPv6 link local address.
• Stateless Address 0-4
Displays the IPv6 stateless addresses obtained from a Router Advertisement.
• Stateful Address
Displays the IPv6 stateful address.
• Manual Config. Add.
Specifies the machine's IPv6 address when DHCP is not used.
• IPv6 Gateway Address
136