Crestron Isys TPS-4500LV Operation Manual page 24

12 inch tilt and lectern touchpanels with video
Hide thumbs Also See for Isys TPS-4500LV:
Table of Contents

Advertisement

12 Inch Tilt/Lectern Touchpanels
20 • 12 Inch Tilt/Lectern Touchpanels with Video: TPS-4500V & TPS-4500LV
Direct Mounting
The TPS-4500LV is a low-voltage unit that can be installed directly into a mounting
surface. Each touchpanel is provided with mounting hardware and accessories, as
shown in the table after this paragraph.
TPS-4500LV Supplied Mounting Hardware and Accessories
ITEM
Large Metal Mounting Plate
Small Metal Mounting Plate
Template
Screw, Pan Phillips
Connector
Connector
NOTE: For cutout dimensions, refer to "Appendix B: Cutout Detail of Supplied
Template" on page 44.
Complete the following installation procedure in the order provided. The only tools
required are a gypsum board saw (or equivalent), a #2 Phillips tip screwdriver, a
drill, a 5/16" bit, and a #20 bit. Complete the following installation procedure in the
order provided.
1. Locate an area on the wall that is free of miscellaneous wiring and
studs.
2. Make a small hole near the middle of the designated site; verify that the
location is suitable.
3. Fasten cutout template (40049, supplied) to mounting surface; verify
that the template is level.
4. Cut out and remove the traced shape of the mounting surface.
5. Drill four 5/16" holes as marked on template. Refer to "Appendix B:
Cutout Detail of Supplied Template" on page 44 for an illustrative
reference.
6. Drill 12 holes marked "A" on template with #20 bit. Refer to
"Appendix B: Cutout Detail of Supplied Template" on page 44 for an
illustrative reference.
7. Slide one large metal mounting plate through the opening and position
it inside along the top horizontal edge.
8. Position one small metal mounting plate along the top horizontal edge
so that it covers the two center holes marked "A".
9. Use two pan head screws, supplied, to secure the bracket and plate to
the mounting surface. Tighten by hand; do not fully tighten screws.
Crestron TPS-4500V & TPS-4500LV
PART NUMBER
MTPL02553-1
MTPL02523-1
OV40049-1
#6-32 x 1" LG
JHPS197SG04SR-2
JHPS138SG06SR-2
Operations Guide - DOC. 6160
QUANTITY
2
2
1
12
1
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Isys tps-4500v

Table of Contents