Table of Contents
Advertisement
Crestron TPS-4500V & TPS-4500LV
Operations Guide - DOC. 6160
3. As shown after this step, select the Net ID of the TPS-4500V/LV
touchpanel and then click OK. The "Touch Panel Transfer" window
appears (refer to the subsequent graphic).
"Select Network ID" Window
NOTE: If problems occur when transferring any Cresnet file (touchpanel
project/firmware), lower the port speed baud rate to 38400 to match the Cresnet bus
speed when transferring through a control system.
"Touch Panel Transfer" Window
Additional choices include Do not send graphic files and Do not send sound files.
These are often very large files that take a long time to load.
4. Click Browse. The "Open" window appears as shown in the following
illustration.
12 Inch Tilt/Lectern Touchpanels with Video: TPS-4500V & TPS-4500LV • 37
12 Inch Tilt/Lectern Touchpanels
Check Send Direct to Wired Touchpanel if
connected via RS-232 directly to touchpanel.
Each time a project is selected
using the Browse command, that
project is added to the File Name
drop-down list. This makes it
convenient to recall projects
without need to browse to a
directory. To delete the list click
Clear History.
All Files in Project: sends the
entire project.
Only Changed Files: sends only
the files that are different from
those that are currently stored in
the panel. Note that if any pages in
the panel are not present in the
project, those pages will be
deleted from the panel.
Advertisement
Table of Contents
