Configuration Differences - Crestron STX-1600C Operation Manual

4 • Series STX Touchpanels
CRESTRON
Power buttons and LED indicators, shown below, are located on the touchpanel base
just left of the position lock button. Two membrane buttons, OFF and ON, can be
used to deactivate and activate the touchpanel when needed. The ON button has a
LED behind the membrane. It illuminates when the touchpanel is active. Three other
LEDs are positioned to the right of the membrane buttons: RF SIG, BATTERY
LOW, and BATTERY CHG. RF SIG illuminates when the touchpanel
communicates with the CNRFGWX transceiver. BATTERY LOW illuminates when
the battery packs in the touchpanel have a low charge. BATTERY CHG illuminates
while the low or discharged battery packs inserted in the touchpanel are slow
charged; assuming the touchpanel is powered from the external power pack or the
network.
Power Switch and Indicators (Close-Up)

Configuration Differences

There are three Series STX configurations available and selection depends on color
versus grayscale display, display size, and memory. A configuration is defined by an
alphanumeric suffix after STX. Refer to the table shown below for a concise listing
of each Series STX configuration. Following the table, front views of each STX
touchpanel are shown.
Series STX Touchpanel Configurations
CONFIGURATION
STX-1600C
STX-3000
STX-3500C
Front View of the STX-1600C
DIAGONAL VIEW
DISPLAY
SCREEN
256 Color 5.7 in (14.5 cm)
256 Grayscale 9.4 in (23.9 cm)
256 Color 9.4 in (23.9 cm)
Operations Guide - DOC. 5716A
MEMORY
768 Kbytes
256 Kbytes
1 Mbyte