Table of Contents
Advertisement
CRESTRON
Contrast
NOTE: Contrast adjustment is not available on the STX-3500C configuration.
Screen contrast may need to be altered because of ambient light conditions, panel
temperature, or personal preference. Two contrast buttons, Contrast << and
Contrast >> (Cont << and Cont >> for the STX-1600C), on the Setup Menu may
be held down for continuous and smooth adjustment of the screen.
Brightness
Screen brightness may need to be altered because of ambient light conditions or
personal preference. Three brightness buttons, BRIGHTNESS LOW (BRT LOW
for the STX-1600C), BRIGHTNESS MED (BRT MED for the STX-1600C), and
BRIGHTNESS HI (BRT HI for the STX-1600C), on the Setup Menu may be
selected to assign the backlight setting.
Panel Tracking
NOTE: The panel tracking feature works best when the touchpanel is wired to the
CRESNET system. Crestron does not recommend use of this feature when the
touchpanel communicates via RF.
Panel tracking is a useful communication feature between touchpanels when more
than one touchpanel exists on the network. Panel tracking is enabled when the
PANEL TRACKING button on the Setup Menu, is selected. Selection is indicated
with red text (for STX-1600C) or light gray text (for STX-3000 and STX-3500C).
When enabled, a given touchpanel maintains communication in such a way that a
page change to any touchpanel on the network forces the same page change to all
enabled touchpanels. Panel tracking is disabled when the PANEL TRACKING
button is deselected (shown in black text). When disabled a given touchpanel does
not respond to page changes made to other touchpanels on the network. Panel
tracking is factory set with the PANEL TRACKING button deselected.
Backlight Timeout Menu
NOTE: Display backlight requires warm-up time. A display reaches 80% of its
final level in five minutes and full brightness in 20 minutes.
The touchpanel display hardware life can be lengthened by turning off the backlight
when the touchpanel is inactive. The BACKLIGHT TIMEOUT button (on the
STX-3000 and STX-3500C configurations) and MANAGE POWER button (on the
STX-1600C configuration) on the Setup Menu reveals the Timeout screen, shown
below. The length of touchpanel inactivity can be specified to minimize power
utilization.
Timeout Screen
14 • Series STX Touchpanels
Operations Guide - DOC. 5716A
Advertisement
Table of Contents
