Battery Usage - Crestron STX-1600C Operation Manual

8 • Series STX Touchpanels
CRESTRON
For best cleaning results, use a clean, damp, non-abrasive cloth with any
commercially available non-ammonia glass cleaner. Surrounding plastic enclosure
may not provide a complete water-tight seal. Therefore, apply cleaning solution to
the cloth rather than the surface of the touchscreen. Wipe touchscreen clean and
avoid ingress of moisture beneath panels.

Battery Usage

The touchpanel can be powered via the supplied power pack or two battery packs,
ST-BP. Location and orientation of the ST-BP are shown below. Complete the
following steps in the order provided to insure proper installation.
Battery Polarity
TOP VIEW OF BASE WITHOUT TOUCHSCREEN
(CUT-AWAY VIEW OF BATTERY COMPARTMENT
WITH DOOR OPEN)
CAUTION: Installing battery packs with the wrong polarity does not damage the
touchpanel, but may result in damage to the battery packs if left in the battery
compartment for extended periods.
NOTE: Crestron's ST-BP can be slow charged while in the battery compartment as
long as the power pack is attached and plugged into an outlet or network power is
supplied. It takes approximately 20 hours to slow charge a fully discharged ST-BP.
There is no danger of over charging the ST-BP, so the power packs can be installed
at all times. It only takes 2 hours to charge the ST-BP in Crestron's battery charger,
ST-BC (sold separately).
1. Verify that the touchpanel is resting on a level surface and there are no
obstacles in front of the battery compartment door.
2. Lift the lever on the battery compartment door; the spring-loaded door
pops open slightly on its hinge.
3. Fully open the battery compartment door and insert battery packs;
observe polarity (as illustrated).
4. Close battery compartment door.
RIGHT SIDE VIEW OF STX TOUCHPANEL WITH
BATTERY COMPARTMENT DOOR OPEN
Operations Guide - DOC. 5716A