Crestron STX-1600C Operation Manual page 19

To have the touchpanel return
to the last screen displayed
after the touchpanel
encounters a POWER DOWN
TIMEOUT, refer to the
"Appendix" on page 24 for a
programming remedy.
Operations Guide - DOC. 5716A
CRESTRON
BACKLIGHT TIMEOUT is displayed on the Timeout screen. This setting turns
the backlight off when the touchpanel is inactive for the specified time (shown in
minutes). When the touchpanel is activated, the last screen to be displayed reappears.
A two minute BACKLIGHT TIMEOUT is shown in the illustration. Minutes can
vary from 0 to 120, where 0 disables the timeout. Down and up arrow buttons
(worded buttons, DOWN and UP, appear on the STX-1600C configuration)
decrease and increase the timeout, respectively.
STX POWER DOWN TIMEOUT is displayed on the Timeout screen. This setting
turns off all power when the touchpanel is inactive for the specified time (shown in
minutes). When the touchpanel is activated, the first page of the project appears. A
10 minute STX POWER DOWN TIMEOUT is shown in the illustration. Minutes
can vary from 0 to 120, where 0 disables the timeout. Down and up arrow buttons
(worded buttons, DOWN and UP, appear on the STX-1600C configuration)
decrease and increase the timeout, respectively.
NOTE: BACKLIGHT TIMEOUT should be set low to maximize battery pack
life. However, STX POWER DOWN TIMEOUT should be set greater than
BACKLIGHT TIMEOUT. Otherwise, the BACKLIGHT TIMEOUT is
meaningless.
NOTE: If network power is supplied to the touchpanel, the panel is capable of
detecting network activity and does not power down when the STX POWER
DOWN TIMEOUT is achieved. Recall that the purpose of the timeout is to
maximize battery pack life. BACKLIGHT TIMEOUT is still functional.
After timeout parameters have been set, touch the SAVE TIMEOUTS button in the
lower left corner of the screen to save the new settings. Touch the RETURN button,
located in the bottom right corner of the screen, to display the Setup Menu.
Sound (for STX-1600C only)
The SOUND button, located at the top right corner of the Setup Menu, is used to
display the Sound Menu, shown below. Use this screen to activate audible key
clicks. This feature is a useful feedback tool. Confirmation of a button press on a
touchpanel is acknowledged by an audible click assuming this feature is enabled. To
enable this feature, verify that the KEYCLICK ON button is active (red). An active
KEYCLICK OFF button disables the feature. Volume of the audible click is
controlled with the VOLUME UP and VOLUME DOWN buttons. The unit is
factory set with the sound on.
Sound Menu
Save Setup
It is advisable to regularly save setup parameters if the user is satisfied with the
settings. If parameters are saved, the settings are restored in the event of a power
failure. The SAVE SETUP button located on the Setup Menu (STX-3000 and STX-
Series STX Touchpanels • 15