Hardware Hookup - Crestron DualTouch DTT-18 Operation Manual

DualTouch™ Technology Touchpanel
Hookup Connections for the DTT-18
Power
Supply
Power
Connector
DB9
(Not
Connected)
USB
Connector
to any
USB port
UPX-2
Operations Guide – DOC. 6290

Hardware Hookup

Refer to the following diagram and complete the connections as needed in any order.
NOTE: To prevent overheating, do not operate this product in an area that exceeds
the environmental temperature range listed in the table of specifications.
Consideration must be given if installed in a closed or multi-unit rack assembly since
the operating ambient temperature of the rack environment may be greater than the
room ambient. Contact with thermal insulating materials should be avoided on all
sides of the unit.
NOTE: The maximum continuous current from equipment under any external load
conditions shall not exceed a current limit that is suitable for the minimum wire
gauge used in interconnecting cables. The ratings on the connecting unit's supply
input should be considered to prevent overloading the wiring.
DTT-18
DVI/I RGB
Connector
DVI/RGB
Adaptor
to RGB
Output Port A
VGA/DVI Switch Must Be
in the VGA Position
DualTouch™ Technology Touchpanel: DTT-18 • 11
Crestron DTT-18