Table of Contents
Advertisement
Squaring Blade To
Fence (Miter)
Your miter saw's fence was calibrated at the fac-
tory so it shouldn't require any further adjustment.
However, in the case that your saw is knocked
out of alignment, follow these steps to check and
adjust its accuracy.
Tools Needed
Framing Square ................................................. 1
Hex wrench 6mm .............................................. 1
Phillips Head Screwdriver #2 ............................ 1
To check miter angle for squareness to table:
1.
DISCONNECT MACHINE FROM POWER!
2.
Set miter angle to zero as described on Page
18.
3.
Pull cutting head down and lock.
4.
Lay a framing square flat on miter table
pressed against fence and flat part of blade
(not teeth) (see Figure 80).
Fence
Figure 80. Framing square positioning for miter.
Model T31634/T31635 (Mfd. Since 8/19)
Qty
Blade
— If front or back edge of saw blade is not
flush with framing square, proceed to Step
5.
— If frame is flush against both fence and
blade then miter is calibrated correctly,
proceed to Step 7.
5.
Loosen fence screws shown in Figure 81.
Figure 81. Fence locking screws.
6.
Adjust fence until it is square with blade, then
secure setting by tightening screws.
7.
Check miter scale indicator to see that it
points at zero on scale. If it does not, loosen
indicator screw and reposition before tighten-
ing to secure.
Fence Screws
-43-
Advertisement
Table of Contents
