Omron H5S-B Manual page 8

H5S
Operating Day Shift
If a day change is made in the time setting mode after performing an
operating day shift, the operating day shift setting will be invalid.
The operating day shift setting will not be valid for any program that
continuously runs from the day before the day to which operation
has been shifted.
Set the Mode Switch to RUN.
To shift Saturday's operation to Monday and Tuesday on Friday.
Display and key operation
(Shaded portion indicates
blinking of the indicator.)
1 Depress the Copy Key
for at least 1 s.
2 Specify Monday and
Tuesday with the Shift
and Set Keys.
3 Press the Write Key.
Dimensions
Note: All units are in millimeters unless otherwise indicated.
H5S-B (Flush Mounting Model)
72
8
Display and key operation
(Shaded portion indicates
blinking of the indicator.)
4 Specify Saturday with
the Shift and Set Keys.
5 Press the Write Key.
(The display returns to
the initial screen.)
H5S-FB (Surface Mounting Model)
(The Unit is shown with the enclosed ter-
6
49
minal cover attached.)
Canceling the Setting
To cancel the setting of each
circuit.
Display and key operation
(Shaded portion indicates
blinking of the indicator.)
1 Set the Mode Switch to
the position of the circuit
whose setting is to be
canceled.
2 Press the CLR Key.
3 The message Clr is dis-
played for 1 s, then the
display returns to the ini-
tial screen. (The setting
for circuit 2 can be can-
celed in the same man-
ner.)
H5S
To cancel the operating day
shift program.
Display and key operation
(Shaded portion indicates
blinking of the indicator.)
1 Set the Mode Key to
RUN. Depress the Copy
Key for at least 1 s.
2 Press the Clr Key.
(The display returns to
the initial screen.)
Note: If the operation of steps
already set is not re-
quired, make all the
ON times the same.
The number of steps
will not be, however,
reduced in this case.
Y92F-90 (option)
Track mounting
base