Ethernet; Operation - Siemens SIMATIC RTLS System Manual

Installation with support - Corner installation
Follow the steps below to mount the device to a corner:
1. Use the corner support as template and draw the bore holes on the corner.
2. Drill the holes with a suitable device.
3. Insert the matching anchors in the holes. (Anchors are not supplied with the device.)
4. Mount the corner support to the corner.
5. Mount the device to the corner support using the screws (M4). (Screws are not supplied with
the device.)
Installation with support - Mast mounting
Follow the steps below to mount the device to a mast:
1. Use the mast mount as template and draw the bore holes on the mast.
2. Drill the holes with a suitable device.
3. Insert the matching anchors in the holes. (Anchors are not supplied with the device.)
4. Install the mast mount to the mast.
5. Install the device to the mast mount using the screws (M4). (Screws are not supplied with
the device.)
Note
If drilling is not possible, you can also fasten the mast mount to the mast with cable ties, for
example.
6.1.2.3

Ethernet

When installing and connecting the Ethernet connection, observe the applicable general
conditions and their legal basis.
The Ethernet connection is connected to the Ethernet socket of the device. The cable must be
connected to the RJ45 plug before connection to the socket.
For the supply voltage of the device over PoE, a corresponding infrastructure such as PoE
injector or PoE switch is required.
6.1.2.4

Operation

The device is not suitable for operation in hazardous areas.
Operation of the system to EN 60950-1 is only safe when the housing cover is installed (cooling,
fire protection, interference suppression).
In case of emergencies (e.g. when the enclosure is damaged, when liquids or foreign objects
are entering the device), the device must be disconnected from the power supply and
maintenance must be contacted immediately.
System Manual, 04/2019, C79000-G8976-C577-01
Gateways
6.1 SIMATIC RTLS4030G
77