Siemens SIMATIC RTLS System Manual page 181

Caution
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will
be required to correct the interference at his own expense.
IC information
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d`Industrie Canada applicables aux appareils radio
exempts de licence. L`exploitation est autorisée aux deux conditions suivantes :
(1) L`appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l`appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d`en compromettre le fonctionnement.
7.7.4.1 UL
UL HAZ. LOC.
The SIMATIC Ident products meet the requirements of explosion protection according to UL
HAZ. LOC. The products meet the requirements of the following standards:
Document
UL 60079-0
CSA C22.2 NO. 60079-0
UL 60079-7
CSA C22.2 NO. 60079-7
UL 60079-31
CSA C22.2 NO. 60079-31
You will find the current versions of the standards in the currently valid UL HAZ. LOC.
certificates.
System Manual, 04/2019, C79000-G8976-C577-01
Title
Hazardous areas
Part 0: Equipment - General requirements
Hazardous areas
Part 7: Equipment protection by increased safety "e"
Hazardous areas
Part 31: Equipment dust ignition protection by enclosure "t"
Transponder
7.7 SIMATIC RTLS PCB OEM AX
181