Stopping The Unit; Shut Off The Engine; Moving The Unit; Roll Over Protective Structure (Rops) Frame - Basic Instructions - New Holland Workmaster 50 Operator's Manual

STOPPING THE UNIT

Shut off the engine

To shut off the engine, carry out the following procedure
1. Remain in the operator's seat.
2. Bring the tractor to a complete stop.
3. Bring the hand throttle lever to the idle position.
4. Apply the park brake.
5. Place both gear shift levers and the shuttle shift lever
are in neutral position.
6. Place the PTO clutch lever in the disengaged position.
WARNING
7.
Crushing hazard!
ALWAYS make sure the work area is clear of
bystanders and domestic animals before rais-
ing or lowering the equipment.
Failure to comply could result in death or seri-
ous injury.
Move the hydraulic lift position control lever fully for-
ward to lower all hydraulic equipment to the ground.
8. Place the key switch (1) into the "STOP" position.

MOVING THE UNIT

Roll Over Protective Structure (ROPS) frame - Basic instructions

WARNING
Misuse hazard!
Your machine is equipped with an operator
protective structure. DO NOT weld, drill holes,
attempt to straighten, or repair the protective
structure. Modification in any way can reduce
the structural integrity of the structure.
Failure to comply could result in death or se-
rious injury.
WARNING
Crushing hazard!
Always wear the seat belt when operating the
machine with the Roll Over Protective Struc-
ture (ROPS) in the upright position.
ROPS is in the folded position, the seat belt
should not be used. Raise the ROPS and wear
the seat belt as soon as conditions allow.
Failure to comply could result in death or se-
rious injury.
4 - OPERATING INSTRUCTIONS
W0123A
Roll-over hazard!
A folded Roll-Over Protective Structure
(ROPS) does not provide roll-over protection.
Do not operate the machine with the ROPS
folded as a standard operating mode. Raise
the ROPS immediately after low clearance
use or transport.
Failure to comply could result in death or se-
W0001B
rious injury.
Roll-over hazard!
Always pull from the drawbar. DO NOT attach
If the chains or ropes to the Roll Over Protective
Structure (ROPS) for pulling purposes, as the
machine could tip over. When driving through
door openings or under low overhead objects,
make sure there is sufficient clearance for the
ROPS.
W0462A
Failure to comply could result in death or se-
rious injury.
4-6
GNIL14TR00559AA
WARNING
WARNING
1
W0938A
W0463A