Toro Greensmaster Flex 1800 Service Manual page 71

Removal (Fig. 44)
1. Park machine on a level surface. Make sure engine
is OFF.
2. Remove transmission drive belt (refer to Transmis-
sion Drive Belt in this manual).
3. Remove cotter pin (item 11) and clevis pin (item 10)
that secure extension spring to clutch assembly spring
anchor. Separate spring from anchor.
4. Support clutch assembly to prevent it from falling.
5. Remove four (4) washer head screws (item 18) that
secure clutch assembly to transmission housing.
6. Remove entire clutch assembly from transmission
housing.
Greensmaster Flex 1800/1820/2100/2120
Installation (Fig. 44)
1. Position clutch assembly to transmission housing
and secure with four (4) washer head screws (item 18).
Tighten screws as follows:
A. First, torque all four (4) screws from 15 to 40 in-
lb (1.7 to 4.5 N- m).
B. Then, torque all screws from 85 to 95 in- lb (9.6
to 10.7 N- m).
2. Position extension spring to clutch assembly spring
anchor. Secure spring to anchor with clevis pin (item 10)
and cotter pin (item 11).
3. Install transmission drive belt and all machine com-
ponents removed for clutch system removal (refer to
Transmission Drive Belt in this manual).
4. Verify that traction clutch cable is properly adjusted
(see Reel Clutch Adjustment - 1820/2120 in this Chap-
ter).
5. Check clutch fluid level:
A. With cutting unit attached, position machine on a
level surface with drive drums and cutting unit rollers
on the ground.
B. Fluid level should be within 0.06 inch (1.5 mm)
from the bottom of the clutch housing check hole
plug.
Page 4 - 41 Traction and Reel Drive System