Toro Greensmaster Flex 1800 Service Manual page 160

NOTE: To prevent cutting reel from turning when instal-
ling drive pulley, use a 1/2" socket on hex of reel drive
shaft that is used for backlapping the cutting reel.
9. Secure drive pulley (item 4) to cutting reel shaft.
Torque pulley to 100 ft−lb (135 N−m).
10.Insert front roller into LH groomer arm assembly.
11. Make sure that bushing (item 11) is installed in RH
drive plate assembly.
12.Apply antiseize lubricant to threads of RH groomer
arm lift rod.
13.Position RH groomer arm assembly to front roller,
groomer RH drive plate and cutting unit frame. Secure
groomer arm to cutting unit with plow bolt (item 22), HOC
washer (item 16) and HOC nut (item 21).
14.Secure RH groomer arm assembly to RH drive plate
with spring washer (item 12) and lock nut (item 13).
Belt Driven Groomer (Optional)
15.Center front roller to cutting unit and tighten cap
screws (item 10) to secure roller.
16.Install groomer drive belt (item 3) and groomer drive
cover (item 2) to RH drive plate (see Groomer Belt Re-
placement in this section).
17.Check grooming reel height and mower height−of−
cut settings. Adjust as needed.
18.Install cutting unit to the machine.
19.Lubricate groomer bearings (see Groomer Installa-
tion Instructions).
NOTE: After greasing groomer bearings, operate
groomer for 30 seconds, stop machine and wipe excess
grease from groomer shaft and seals.
Page 8 − 12 Greensmaster Flex 1800/1820/2100/2120