Toro Greensmaster Flex 1800 Service Manual page 197

Assembling the Height Adjuster Assembly
Greensmaster Flex 1800/1820/2100/2120
12188SL Rev D
1. Apply anti-seize lubricant to the upper threads of the adjustment rod and
lower threads of the height adjusters. Assemble the height adjuster assembly
(Figure 12).
2. If both the height adjusters are removed, fit 1 height adjuster assembly to the
cutting unit side plate and secure it with the carriage bolt and flange nut. Do
not tighten the flange nut at this time. Ensure that the height adjustment bolt
and 1 washer is above the slot in the side plate and 1 washer and locknut is
below the slot in the side plate.
3. Position front roller between the height adjuster assemblies and secure
height adjuster assembly to cutting unit side plate with carriage bolt and
flange nut. Do not tighten the flange nut at this time. Ensure the height
adjustment bolt and 1 washer is above slot in side plate and 1 washer and
locknut is below slot in side plate.
4. Install new cotter pins and clevis pins and secure the height adjustment rods
to the groomer gear box and idler arm.
5. Adjust the cutting unit height-of-cut; refer to Cutting Unit Operators Manual.
6. Check the groomer reel height and adjust as necessary.
g207293
1. Height adjustment knob
7. Adjust the flange nuts (item 8 in
rods until the springs are compressed to 16 mm (0.625 inch).
Figure 13
Figure 12) on the groomer height adjustment
Page 9–23 Universal Groomer (Optional): Service and Repairs