Toro Greensmaster Flex 1800 Service Manual page 107

Installation
1. Secure traction clutch cable to the traction lever as-
sembly (Fig. 10):
A. Install cable spring to spring anchor on lever as-
sembly.
B. Slide the cable housing into the shift mount
bracket slot. Make sure that a jam nut, flat washer
and lock washer are on both sides of bracket. Adjust
jam nuts so that equal amount of cable threads are
visible above and below jam nuts. Leave jam nuts
snug until final cable adjustment.
2. Route traction clutch cable to the transmission and
install cable to transmission (Fig. 9):
A. Secure cable eyelet to transmission traction lever
with flange nut.
B. Position traction cable to the casting slot of trans-
mission with a jam nut, flat washer and lock washer
on each side of the slot. Adjust and tighten jam nuts
so that equal amount of cable threads are visible
above and below jam nuts.
3. Make final traction clutch cable adjustment at trac-
tion lever assembly. Adjust cable jam nuts to remove
slack in cable without rotating the transmission bell-
o
crank lever more than 3
mm) at slot).
4. Install console cover to handle assembly.
Greensmaster Flex 1800/1820/2100/2120
(approximately 0.060" (1.5
Page 6 − 9
1
3
5
Figure 9
1. Traction clutch cable
2. Transmission
3. Traction cable bracket
4
5
6
2
Figure 10
1. Shift handle
2. Traction clutch cable
3. Reel clutch cable
4. Traction cable spring
4
2
4. Flange nut
5. Bellcrank lever
1
7
3
5. Upper cable jam nut
6. Lower cable jam nut
7. Shift mount bracket
Chassis and Controls