Toro Greensmaster Flex 1800 Service Manual page 157

Installation
1. If removed, install shaft into groomer cover (Fig. 5):
A. Install new O−ring into groove of shaft.
B. Apply antiseize lubricant to shaft surface that is
below the retaining ring groove.
C. Slide shaft up through bore of cover and secure
with thrust washer and retaining ring.
D. Position shaft in cover so that cam point of shaft is
located away from the gasket surface (Fig. 6).
E. Install plunger detent into groomer cover so that
end of plunger if from flush to 0.020" (0.5 mm) ex-
tending from cover surface (Fig. 6).
F. Slide handle into shaft so that it extends toward
the front of the cover.
G. Apply Loctite #242 (or equivalent) to threads of
set screw. Install set screw into end of shaft to secure
handle in place.
2. Install groomer cover assembly to RH drive plate as-
sembly (Fig. 4):
A. Make sure that handle on groomer cover is ro-
tated toward the front of the machine.
B. Fill groomer cover with approximately five (5)
ounces (142 grams) of Mobil XHP221 grease (or
equivalent).
C. Install new gasket and then groomer cover as-
sembly to RH drive plate. Secure cover with five (5)
flange head screws.
Greensmaster Flex 1800/1820/2100/2120
Flush to 0.020"
(Flush to 0.5 mm)
3
1. Shaft
2. Cam point
Page 8 − 9
2
Figure 6
3. Plunger detent
Belt Driven Groomer (Optional)
1