Toro Greensmaster Flex 1800 Service Manual page 139

IMPORTANT: To avoid grinding the reel, do not
contact the cutting edge of any blade with the pry
bar as this may damage the cutting edge and/or
cause a high blade.
B. Move the pry bar against the weld side of the reel
support plate closest to the bearing lock screw.
IMPORTANT: The reel drive shaft on the left end
of the cutting reel has left- hand threads. The
bearing lock screw on the right end of the cutting
reel has right- hand threads.
C. Rest the handle of the pry bar against the front
roller and tighten the bearing lock screw from 90 to
110 ft- lb (123 to 149 N- m).
IMPORTANT: Do not use 1/2" extension on end of
reel drive shaft when loosening or tightening
drive shaft. The 1/2" hex is intended for backlap-
ping only.
D. Position the pry bar in the same manner on the
opposite end of the reel and use the appropriate
wrench or socket on the 1" hex portion of the shaft to
tighten the reel drive shaft from 90 to 110 ft- lb (123
to 149 N- m).
10.Adjust cutting unit (see Cutting Unit Operator's
Manual).
Greensmaster Flex 1800/1820/2100/2120
NOTE: The parallel position of the rear roller to the cut-
ting reel is controlled by the precision machined cross-
member and side plates of the cutting unit. If necessary,
the cutting unit side plates can be loosened and a slight
adjustment can be made to parallel the rear roller with
the cutting reel (see Leveling Rear Roller in the Set- Up
and Adjustments section of this Chapter).
11. Install reel pulley, belt and reel drive cover to reel
drive assembly. Refer to Reel Drive Assembly in the
Service and Repairs section of Chapter 4 - Traction and
Reel Drive System for procedure to install and adjust
these components.
12.Install cutting unit to the machine.
Page 7 - 21 Cutting Unit