Toro Greensmaster Flex 1800 Service Manual page 191

Removing the Idler Assembly (continued)
Installing the Idler Assembly
Greensmaster Flex 1800/1820/2100/2120
12188SL Rev D
5. Inspect the shields, bearing, and bushing in the idler assembly. Remove and
discard the components that are worn or damaged.
1. If the shields, bearing, or bushing was removed from the idler arm, install
new components as follows:
A. Press the bushing into a groomer plate until the bushing is centered in
the idler arm bore.
B. Press the bearing into the idler arm so that the bearing contacts the
shoulder in idler arm bore and install the bearing retaining ring.
C. Install the bearing shields with flocked side of shield toward the bearing.
D. Check the idler arm orientation and insert the stub shaft through shields
and bearing. Use the through hole in the shaft to prevent shaft from
rotating, tighten the flange nut to 37 to 45 N∙m (27 to 33 ft-lb).
E. If the collar was removed from the idler arm, install the collar and tighten
to 33 to 41 N∙m (24 to 30 ft-lb).
2. Apply anti-seize lubricant to the inside diameter of the idler arm.
3. Install a new cotter pin and clevis pin and secure the height adjustment rod
to the front of the idler arm.
4. Install reel drive assembly, reel pulley, reel drive belt and then reel drive
cover to left side of cutting unit (see Reel Drive Assembly in the Service and
Repairs section of Chapter 4 - Traction and Reel Drive System).
Page 9–17 Universal Groomer (Optional): Service and Repairs