Table of Contents
Advertisement
2.
Detach the NFC module antenna cable (2) from the computer. The NFC module antenna cable is
attached to the computer with double-sided adhesive.
3.
Remove the four Phillips M2.0 × 2.0 broadhead screws (3) that secure the touchpad to the computer.
4.
Remove the three Phillips M1.6 × 2.0 screws (4) that secure the touchpad to the computer.
5.
Remove the touchpad (5) from the computer.
To replace the touchpad, reverse the removal procedure.
Card reader cable
To remove the card reader cable, use this procedure and illustration.
The card reader cable and nano SIM cable are included in the Cable Kit, spare part number N96591-001.
Before removing the card reader cable, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the card reader cable:
1.
Release the ZIF connector (1) the card reader cable is connected to, and then disconnect the card
reader cable from the system board.
2.
Release the ZIF connector (2) the card reader cable is connected to, and then disconnect the card
reader cable from the card reader.
Preparation for disassembly on page
Bottom cover on page
Battery on page
54).
42).
54).
Card reader cable
85
Advertisement
Table of Contents
