Table of Contents
Advertisement
9 Mounting the Cutting Attachment
9
Mounting the Cutting
Attachment
9.1
Placing power tool on the
ground
► Shut off the engine.
► Lay your power tool on its back so that the cut‐
ting attachment mounting face is pointing up.
9.2
Blocking the Shaft
The drive shaft must be blocked with the stop pin
to mount and remove the cutting attachment.
The stop pin is included with the machine and is
available as a special accessory.
1
► Insert the stop pin (1) in the bore (2) in the
gearhead as far as stop, apply slight pressure.
► Rotate the output shaft (3) until the stop pin
slips into position.
► Push it home as far as stop.
0458-262-0121-C
3
2
9.3
Removing the Mounting Hard‐
ware
5
6
3
7
► Block the shaft.
► Use the combination wrench (4) to loosen and
remove the nut (5) clockwise (left-hand
thread).
► Take the thrust washer (6) off the shaft (3). Do
not remove the thrust plate (7).
9.4
Mounting Metal Cutting Attach‐
ment
Keep the leaflet and packaging of the metal cut‐
ting attachment in a safe place.
WARNING
Wear protective gloves to reduce the risk of
direct contact with the sharp cutting edges.
Mount only one metal cutting attachment.
English
4
13
Advertisement
Table of Contents
