Mounting The Cutting Attachment - Stihl FS 510 C Instruction Manual

English
NOTICE
Only use the 60-mm diameter thrust
plate. The 65-mm diameter thrust plate
is too big and must not be used – see
chapters "Mounting the Cutting
Attachment" / "Mounting the Mowing
Head" / "Mounting Grass Cutting
Blades".
6
1
Place the guard washer (6) on the
N
thrust washer – the whole collar
(arrows) on the shaft (1) must be
visible.
22
Mounting the Cutting
Attachment
Placing power tool on the ground
Shut off the engine.
N
Lay your power tool on its back so
N
that the cutting attachment
mounting face is pointing up.
Mounting Hardware for Cutting
Attachment
The mounting hardware supplied
depends on the cutting attachment that
comes as original equipment with the
new machine.
The appropriate deflectors and
mounting hardware are available as
special accessories for subsequently
equipping the machine with different
cutting attachments – see chapter on
"Special Accessories".
WARNING
Always use and assemble the cutting
attachment mounting hardware as
described in the chapter on "Mounting
the Cutting Attachment".
Thrust plate
A
60 mm (2.4 in) diameter (A) version
–
for mounting mowing heads and
grass cutting blades
65 mm (2.6 in) diameter (A) version
–
for mounting brush knives, shredder
blades and circular saw blades
NOTICE
The thrust plate is necessary for
mounting all cutting attachments to the
gearbox.
Thrust washers
A
60 mm (2.4 in) diameter (A) version
–
for mounting grass cutting blades
and circular saw blades
70 mm (2.8 in) diameter (A) version
–
for mounting brush knives and
shredder blades
FS 510 C, FS 560 C
A
A