Table of Contents
Advertisement
2 Safety Precautions and Working Techniques
Always replace damaged parts. Never operate
the unit with a damaged deflector
– Never attempt to modify the controls or safety
devices
– Keep the handles dry and clean – free from oil
and dirt – this is important for safe control of
the machine
– Adjust the harness and handles to suit your
height and reach – see "Fitting the Harness".
To reduce the risk of personal injury, do not
operate your machine if it is not in a safe condi‐
tion.
To prepare for emergencies when using a har‐
ness: Practice setting down the machine quickly.
To avoid damage, do not throw the machine to
the ground when practicing.
2.5
Starting the engine
Start the engine at least 3 meters from the fuel‐
ing spot, outdoors only.
Place the unit on firm ground in an open area.
Make sure you have good balance and secure
footing. Hold the unit securely. The cutting
attachment must be clear of the ground and all
other obstructions because it may begin to run
when the engine starts.
Your power tool is a one-person unit. To reduce
the risk of injury from ejected objects, do not
allow other persons within a radius of 15 meters
of your own position – even when starting.
Avoid contact with the cutting attach‐
ment – risk of injury!
Do not drop-start the power tool –
start the engine as described in the
User Manual. The cutting attachment
runs on for a short while after releas‐
ing the throttle trigger – coasting
effect!
Check engine idling: The cutting attachment
must remain at a standstill when the engine idles
– throttle trigger released.
Keep easily combustible materials (e. g., wood
chips, bark, dry grass, fuel) away from hot
exhaust gases and hot muffler surfaces – risk of
fire!
0458-262-0121-C
2.6
Holding and guiding the
machine
Always hold the unit firmly with both hands on
the handles.
Make sure you always have good balance and
secure footing.
Right hand on control handle, left hand on grip
on handlebar.
2.7
While working
Make sure you always have good balance and
secure footing.
In the event of impending danger or in an emer‐
gency, switch off the engine immediately - move
the slide control/stop switch to STOP or 0.
15m (50ft)
Within a wide area around the workplace, there
is a risk of accident by ejected objects, therefore
ensure that there is no-one within a 15 m radius
of the machine. This distance must also be main‐
tained in relation to objects (vehicles, window
panes) – risk of property damage! Even at a dis‐
tance over 15 m, danger cannot be ruled out.
Never touch the rotating cutting
attachment – risk of serious injury.
Check that the engine is properly idling so that
the cutting tool will not continue rotating after you
release the throttle trigger.
Check and correct the idle speed setting at regu‐
lar intervals. If the cutting attachment still rotates
at idle speed, have your dealer make proper
English
5
Advertisement
Table of Contents
