Table of Contents
Advertisement
English
12.3.1
Fitting the carrying ring
1
1
► Place the clamp (1) against the drive tube with
the tapped hole on the left (viewed from
engine).
► Squeeze the two ends of the clamp together
and hold in that position.
► Insert the M6x14 screw (2).
► Line up the carrying ring.
► Tighten down the screw firmly.
18
2
12.3.2
Putting on the shoulder strap
► Put the shoulder strap (1) over your left shoul‐
der.
► Adjust the length of the strap so that the cara‐
biner (2) is about a hand's width below your
right hip.
12.3.3
Attaching machine to shoulder strap
1
2
► Attach the carabiner (1) to the carrying ring (2)
on the drive tube.
12.3.4
Holding and controlling the power tool
► Let the machine go until it is balanced, then
check the floating position.
12 Fitting the Harness
1
2
2
1
0458-262-0121-C
Advertisement
Table of Contents
