Table of Contents
Advertisement
5 Mounting the Bike Handle
9
8
2
► Fit the handlebar (6) in the handle support –
the rubber handle (7) must be on the left
(viewed from the engine).
► Place the clamp (8) on the handle support and
handlebar.
► Insert the screws (9) through the holes in the
parts and screw them into the lower clamp (2)
– do not finally tighten yet.
5.2
Aligning the handlebar
► Fasten the handlebar (1) before the motor at a
distance A of approx. 43 cm (17 in.) ahead of
the engine on the shaft (2)
► Line up the handlebar and tighten down the
screws firmly
0458-262-0121-C
7
6
A
1
2
5.3
Mounting the Control Handle
3
1
2
► Unscrew the screw (1) – the nut (2) remains in
the control handle (3)
► Push the control handle with the throttle trig‐
ger (4) facing toward the gearbox onto the
handlebar (5) until the holes (6) align
► Insert and tighten screw (1)
5.4
Fastening the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in tight radii
– make sure the throttle trigger moves freely.
2
1
1
2
► Position the throttle cable retainer (2) and the
throttle cable (1) on the shaft
► Squeeze the throttle cable retainer (2). The
throttle cable retainer (2) engages in position
with an audible click
English
4
6
5
6
2
11
Advertisement
Table of Contents
