Cruise Control Set Indicator Light (If Equipped); Headlight Indicator Light; Front Fog Light Indicator Light; Rear Fog Light Indicator Light (If Equipped) - Subaru Outback 2011 Owner's Manual

3-38
Instruments and controls
. If this indicator light does not illumi-
nate even when you press the
"CRUISE" main switch, the cruise con-
trol system may not operate properly.
We recommend that you have your
vehicle checked by your nearest
SUBARU dealer.
&
Cruise control set in-
dicator light (if
equipped)
The cruise control set indicator light
illuminates when the ignition switch is
turned to the "ON" position and turns off
after approximately 3 seconds.
This light illuminates when vehicle speed
has been set.
&
Headlight indicator
light
This indicator light illuminates under the
following conditions.
. When the light switch is turned to the
" " or " " position
. When the light switch is in the "AUTO"
position and the headlights illuminate
automatically
&
Front fog light indicator
light
This indicator light illuminates while the
front fog lights are illuminated.
&
Rear fog light indicator
light (if equipped)
This indicator light illuminates while the
rear fog light is illuminated.
&
Preheating indicator
light (diesel engine
models)
The preheating indicator light illuminates
when the ignition switch is turned to the
"ON" position and turns off after the
engine has sufficiently preheated (a few
seconds later).
NOTE
. When the weather is cold outside,
the preheating indicator light remains
illuminated a little longer than usual.
. For models without push-button
start system, start the engine after the
preheating indicator light has turned
off.
. For models with push-button start
system, the engine will not start until
the preheating indicator light has
turned off.
&
Diesel particulate filter
warning light
(diesel engine models)
The diesel particulate filter warning light
will illuminate when the ignition switch is
turned to the ON position and then turn off
after 2 seconds. This means that the
diesel particulate filter system is operating
properly.
! When diesel particulate filter warn-
ing light illuminates
The diesel particulate filter warning light
illuminates when the filter is not able to
automatically burn the soot and the
accumulated particulate matter exceeds
the specified limit.
When the diesel particulate filter warning
light illuminates, drive the vehicle under
the following conditions after the engine
has been warmed up completely.
. Vehicle speed: 60 km/h (37 mph) or
more
. Engine speed: 1,800 to 2,500 rpm
. Transmission gear position: 4th, 5th or
6th
. Driving time for burn treatment: 15
minutes or more
. Notes: Do not accelerate rapidly.