Power Saver Mode; Programming Options - Clarion Ungo Pro Security SR1000 Owner's Manual

power saver mode

Your system will automatically enter Power Saver Mode while armed or
in override mode, after a period of time in which no operation has
been performed. This lowers the current draw on the vehicle's battery.
Power Saver Mode takes over under the following conditions:
Power Saver when the system is armed: After the system has
been armed for 24 hours the LED will flash at half its normal
rate, decreasing the system's current draw.
Power Saver in override mode: When the system enters
override mode the LED illuminates steadily. If the vehicle is not
used (ignition is not turned on) for a one hour period while
the system is in override mode, the LED will shut off. If the
system remains in override mode, the LED will come back on
the next time the ignition is turned on and then back off.

programming options

Programming options control your system's normal, operational set-up.
Most options do not require additional parts, but some may require
installation labor.
The following is a list of the programmable options, with the factory
settings in Bold.
Active arming (remote only) or passive arming (automatic
arming 30 seconds after the last door has been closed).
28