Warranty shall be limited to the repair or replacement of the product, at the sole discretion of Clarion. If it becomes necessary to send the product or any defective part to Clarion, the product must be shipped in its original carton or equivalent carton, fully insured, with shipping charges prepaid.
Page 3
ALSO HAVE THE OTHER RIGHTS, WHICH VARY FROM STATE TO STATE. Should you have any difficulties with the performance of this product during warranty, please call: 1-800-GO-CLARION or visit your local Ungo Pro Security dealer. You may also contact the National Service Manager at the following address below for additional service help you may need.
Control module Receiver/antenna Two four-button remotes Blue status LED indicator light Push-button Override switch Shut-down toggle switch important information Congratulations on the purchase of your remote engine start keyless entry system. Due to the complexity of this system, it must be installed by an authorized dealer only.
FCC/ID notice This device complies with Part 15 of FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful inter- ference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. Changes or modifications not expressly approved by the party responsi- ble for compliance could void the user's authority to operate this device.
standard configuration Button The lock and panic functions are controlled by pressing on the remote for one second. Button The unlock function is controlled by pressing on the remote for one second. Button Silent Lock/Unlock and an optional auxiliary function are controlled by this button in conjunction with the button.
When parking in an enclosed or partially enclosed area or when having the vehicle serviced, the remote engine start system must be disabled using the installed toggle switch. It is the user's sole respon- sibility to properly handle and keep out of reach from children all remotes to assure that the system does not unintentionally remote engine start the vehicle.
Page 10
gear. This testing should be performed by an authorized dealer in accor- dance with the Safety Check outlined in the product installation guide. If the vehicle starts in gear, cease remote engine start operation imme- diately and consult with the authorized dealer to fix the problem. After the remote engine start module has been installed, contact your authorized dealer to have him or her test the remote engine start module by performing the Safety Check outlined in the product instal-...
locking Pressing for one second locks the doors (if the door locks are con- nected) and activates the starter kill. The horn will honk (if connected) and the parking lights will flash once to confirm arming of the system. While the system is locked, the status LED will flash once per second.
If your remote is lost or damaged, you can manually override the starter kill. To do this, you must have the vehicle's ignition key and know where the Override switch is located. Be sure to check with the installer for the location of the Override switch.
Turn the ignition on. Turn the ignition off. Press and release the Override switch within 10 seconds. The status LED will light continuously if you are entering override mode and will turn off if you are exiting override mode. panic mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your remote.
remote engine start This feature allows you to remotely start and run your vehicle for a pro- grammable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehicle with the climate control system.
Page 15
The brake pedal is pressed. The hood is opened. The shutdown toggle switch is put into the OFF position. The pre-programmed run time (12, 24, or 60 minutes) has elapsed. Remote button...
Before turning off the engine, press and release remote twice in 3 seconds (or press and release the optional momentary switch). The parking lights will flash for confirmation. Turn the ignition key to the OFF position. (The engine will stay running.) The engine will run until the pre-programmed time elapses or a shut-down input is received.
The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down wires. To exit timer mode, turn the ignition switch on any time the engine is running. The parking lights will flash 4 times, indicating timer mode has been exited.
This feature is useful if the vehicle is being serviced or stored in an enclosed area. To disable the remote engine start, move the shutdown toggle switch to the OFF position. The switch can be installed in a location of your choice. Check with your installer for recommended locations.
power-up This system will store its current state to non-volatile memory. If power is lost and then reconnected the system will recall the stored state from memory. This means if the unit is in override mode and the battery is disconnected for any reason, such as servicing the car, when the bat- tery is reconnected the unit will still be in override mode.
Page 20
Ignition switch-controlled door-locking on or off. With this feature on, the doors will lock 3 seconds after the ignition key is turned on, and unlock when the ignition key is turned off. Passive Locking or Active Locking (doors lock only with the remote).
The vehicle is never prevented from cranking when the system is deactivated, in override mode, or if the starter kill switch itself fails. Your system has feature-ready circuitry for the starter kill, however installation may require additional labor.
convenience expansions Listed below are some of the many expansion options available for use with your system. Some options may require additional parts and/or labor. Please consult with your dealer for a complete list of options available for use with this system. Domelight Supervision: The domelight will illuminate for 30 seconds each time the system is disarmed using the remote.
Page 23
The second system will roll two win- dows both up and down. This second system also provides one touch switch operation. Progressive Door Unlocking: For added security, your system can be configured to unlock the driver’s door only, leaving the passenger doors locked.
(if connected) will honk twice and the parking lights will flash twice. Disabling the Starter Kill without a remote Turn on the ignition. Press and release the Override switch within 10 seconds. The LED will stop flashing and the vehicle should start. Be sure to check with the installer for the location of the Override switch.