Passive Arming - Clarion Ungo Pro Security SR1000 Owner's Manual

passive arming

The system can be programmed to arm itself automatically (called pas-
sive arming). If the system is programmed for passive arming, it will
automatically arm 30 seconds after the ignition is turned off and the
system detects that you have left the vehicle by opening and closing a
door. Whenever the system is in its 30-second passive arming count-
down, the status LED will flash twice as fast as it does when the system
is armed. At the 20-second point of the countdown, the siren will chirp
to indicate that the system is about to arm. At the 30-second point, the
parking lights will flash to indicate that the system is armed.
n n o o t t e e : : If any protected entry point (such as a door or a switch-
protected trunk or hood) is open, the system will not pas-
sively arm (unless forced passive arming is programmed on.
See Programming Options section.) Additionally, each time
a sensor is triggered during the arming countdown, the 30-
second countdown starts over.
When armed your vehicle is protected as follows:
Light impacts trigger the warning signal. When triggered, the
siren chirps and the parking lights flash for a few seconds.
Heavy impacts trip a Triggered Sequence. The sequence
consists of the siren sounding continuously and the parking
lights flashing for a pre-programmed period, which can range
in duration from 1 to 180 seconds.
If a door is opened, the system will immediately start chirping
the siren and flashing the parking lights. Three seconds later,
the siren output changes to a continuous blast. This progres-
sive response gives you time to disarm the system with your
remote if you inadvertently open the door while the system is
10