Table of Contents
Advertisement
SC111 Chassis Manual
Installing the Motherboard
1.
Review the documentation that came with your motherboard. Become familiar
with component placement, requirements, and precautions.
2.
Disconnect the power supply and lay the chassis on a flat surface.
3.
Open the chassis cover.
4.
If necessary, remove the riser card bracket. To do this, remove the two
screws holding the card in place and lift the bracket from the chassis.
5.
As required by your motherboard, install standoffs in any areas that do not
have a permanent standoff. To do this:
A. Place a hexagonal standoff screw through the bottom the chassis.
B. Secure the screw with the hexagon nut (rounded side up).
6.
Lay the motherboard on the chassis aligning the permanent and optional
standoffs
7.
Secure the motherboard to the chassis using the rounded, Phillips head
screws.
8.
Secure the CPU(s), heatsinks, and other components to the motherboard,
chassis, and/or backplane as needed.
Riser Card
Bracket
(remove if
necessary)
Figure 5-7: Installing the Motherboard
5-8
Advertisement
Table of Contents
